Can the filters on p 100 masks be disinfected?

pic related some kinds of filters have this hard plastic case over them

Attached: plastic case.png (320x240, 78.85K)

i got lots of ffp2 mask from work and the valve is installed like right only a rubber thing inside i guess it is made to restrict air flow inwards and make it easier to breathe out. But in every mask there is also filters like the filters on the left side for extra safety conditions i think.

What should i do? should i add the filters or use the mask without the filters.

Attached: mask 2.jpg (1599x799, 117.83K)

im chinese

>9 days
You're fucking retarded

I bought only one as well i wish bought like 10-15 of them lmao. could have even sold them later on if they were of no use

what's the point of changing the filters? I thought that you just pretty much had to wait until it was impossible to breathe using it once the filters became too full? Even if there is live virus on the filters.. just don't touch them and you should be fine?

the p100 particulate filter ones don't have this unfortunately :(

how many days is optimal then?

you only have to discard them if they are compromised or after 8 hours of use in high risk high exposure areas (ie treating infected patients)

1) you do not have enough to discard after every use, you WILL run out and you will NOT be able to get any more

2) spray it with lysol and leave it in the sun the next day and alternate between a pair

as a normie that isnt breathing in trillions of virions into the filter you can use 1/2 pairs almost indefinitely

Attached: 20200316_211227.jpg (2944x2208, 1.66M)

that is a p100, just filters vapors too